|
|
Post by Tristan Gray on Nov 8, 2011 9:18:20 GMT -5
Hi, I'm trying to find out where the seat should go in an X1 28N.
Could someone please help me out with measurements or a seat set up guide.
Kind Regards,
Tristan Gray
|
|
|
|
Post by davidsera on Nov 8, 2011 17:21:27 GMT -5
Hi Tristan, This is a starting setup guide suited to the X1-28N. A little info, people tend to use either a Short Medium axle, or even an 'X' axle. If you use a short Medium have the third bearing loose. 2mm Positive per side camber, 1mm toe out. Neutral - Minimum castor. This will give you a good base setup which you can work on from there. Attachments:
|
|
|
|
Post by tristan on Nov 12, 2011 10:06:15 GMT -5
thanks alot. much appreciated!!!
|
|
|
|
Post by paul p on Dec 13, 2011 21:28:59 GMT -5
Hi Tristan, This is a starting setup guide suited to the X1-28N. A little info, people tend to use either a Short Medium axle, or even an 'X' axle. If you use a short Medium have the third bearing loose. 2mm Positive per side camber, 1mm toe out. Neutral - Minimum castor. This will give you a good base setup which you can work on from there. |
|
|
|
Post by f on Sept 23, 2013 19:21:44 GMT -5
thanks alot. much appreciated!!! |
|
|
|
Post by f on Sept 23, 2013 19:22:51 GMT -5
thanks alot. much appreciated!!! |
|
